Silicone Mould - 2D Panda Sitting - S204 buttercake 110mm width and 65mm height

110mm width and 65mm height

This is a must for any pirate themed party

cupcakes and smaller cakes

Adding a sense of refinement and innocence to your creations

*Custom values available upon request*

Silicone Mould - 2D Panda Sitting - S204 buttercake 110mm width and 65mm heightInstructions: For the best details, lightly dust the mould with cornflour or icing sugar. Press in small amount of sugar paste, gumpaste or fondant, roll gently over the silicone mould with the rolling pin and remove the excess paste with the sharp knife. Tip: For a easy release, put the mould in a freezer for about 30 seconds, or bit longer if needed. Once the gum paste has hardened up a bit, turn the mould over, and the item should pop out easily.